LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2006 >> Raider XLS, RWD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Supplemental Restraint System (SRS) >> Electrical Diagnostics >> Diagnosis And Testing >> DTC B2212: Occupant Classification Module Internal >> Diagnostic Test

Diagnostic Test

  1. VERIFY ACTIVE DTC 
    NOTE: Ensure that the passenger seat is empty.
    1. Turn the ignition off, wait 10 seconds and turn ignition on.
    2. With the scan tool, read OCM DTCs.

    Q: Did the DTC: B2212-OCCUPANT CLASSIFICATION MODULE INTERNAL reset? 

    YES  : Go To 2

    NO  : Perform the *OCS VERIFICATION TEST-VER 1.

  2. PERFORM OCCUPANT CLASSIFICATION MODULE SYSTEM VERIFICATION TEST 
    1. Verify that the passenger seat is empty.
      NOTE: Failure to follow the test instructions or aborting the test will cause faults to set when performing the Occupant Classification Module System Verification Test. To prevent faults due to process errors: Verify That All Tests Steps That Led You Here Were Performed As Directed; Verify That The Ignition Is In Run; Wait 30 Seconds After Changing The Seat Weight Before Proceeding To Allow The System To Stabilize; Only Press Scan Tool Buttons When Directed To Do So; & Perform The Occupant Classification Module System Verification Test To Completion.
    2. With the scan tool in OCM, select More Options, select System Tests, and select Occupant Classification Module System Verification Test. Run the test by following the instructions displayed on the scan tool. When the test is complete, proceed as follows.
    3. With the scan tool, read OCM DTCs.

    Q: Does the scan tool display any active DTCs? 

    Yes  :

    • Go To 3

    Yes  :

    No  :

    • Perform *OCS VERIFICATION TEST - VER 1.
  3. VERIFY SENSOR TORQUE 
    1. Verify that the passenger seat is empty.
    2. Verify that all of the Seat Weight Sensor mounting screws are torqued to specification. Refer to SEATS .
      NOTE: Failure to follow the test instructions or aborting the test will cause faults to set when performing the Occupant Classification Module System Verification Test. To prevent faults due to process errors: Verify That All Tests Steps That Led You Here Were Performed As Directed; Verify That The Ignition Is In Run; Wait 30 Seconds After Changing The Seat Weight Before Proceeding To Allow The System To Stabilize; Only Press Scan Tool Buttons When Directed To Do So; & Perform The Occupant Classification Module System Verification Test To Completion.
    3. With the scan tool in OCM, select More Options, select System Tests, and select Occupant Classification Module System Verification Test. Run the test by following the instructions displayed on the scan tool. When the test is complete, proceed as follows.
    4. With the scan tool, read OCM DTCs.

    Q: Does the scan tool display any active DTCs? 

    Yes  :

    • B2212 is ACTIVE?
      WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.
      WARNING: If the Occupant Classification Module is dropped at any time, it must be replaced. Failure to take proper precautions can result in accidental airbag deployment and personal injury or death.

      Replace the Occupant Classification Module (OCM) in accordance with the service information.

    • Perform *OCS VERIFICATION TEST - VER 1

    Yes  :

    No  :

    • Perform *OCS VERIFICATION TEST - VER 1.