DTC P0594: Speed Control Servo Power Relay Circuit: Notes
For a complete wiring diagram, refer to SYSTEM WIRING DIAGRAMS .
- When Monitored:
With the ignition key on. The speed control switched on .
- Set Condition:
The speed control power supply circuit is either open or shorted to ground. One Trip Fault. Three good trips to turn off the MIL .
Possible Causes
(V32) S/C SUPPLY CIRCUIT OPEN
(V32) S/C SUPPLY CIRCUIT SHORTED TO GROUND
(V30) S/C BRAKE SWITCH OUTPUT CIRCUIT OPEN
(V30) S/C BRAKE SWITCH OUTPUT CIRCUIT SHORTED TO GROUND
STOP LAMP SWITCH
PCM
Always perform PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding.