Theory of Operation
This diagnostic provides a continuous check of the O2 heater circuit during operation. The heater circuit is momentarily disabled to allow a resistance measurement to be taken to infer heater temperature. The current delivery to the heater is duty cycled to maintain a specific target temperature. The error from the target temperature is continuously monitored to assess heater performance.
- When Monitored:
Engine running and heater duty cycle greater than 0%. Battery voltage greater than 11.0 volts .
- Set Condition:
No sensor output is received when the PCM powers up the sensor heater. Two trip fault. Three good trips to turn off the MIL .
Possible Causes
(K199) O2 2/1 HEATER CONTROL CIRCUIT OPEN
(Z934) O2 HEATER GROUND CIRCUIT OPEN
O2 SENSOR HEATER ELEMENT
PCM
Always perform PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding.