DTC P0113: Intake Air Temperature Sensor Circuit High: Notes
For a complete wiring diagram, refer to SYSTEM WIRING DIAGRAMS .
- When Monitored:
With the ignition on. Battery voltage greater than 10.4 volts .
- Set Condition:
The Intake Air Temperature (IAT) sensor circuit voltage at the PCM goes above 4.98 volts for 2.8 seconds. One Trip Fault. Three good trips to turn off the MIL .
Possible Causes
(K21) IAT SIGNAL CIRCUIT SHORTED TO BATTERY VOLTAGE
(K21) IAT SIGNAL CIRCUIT OPEN
(K900) SENSOR GROUND CIRCUIT OPEN
IAT SENSOR
PCM
Always perform PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding.