DTC P0038: O2 Sensor 1/2 Heater Circuit High: Notes
For a complete wiring diagram, refer to SYSTEM WIRING DIAGRAMS .
- When Monitored:
Battery voltage above 10.6 volts, ASD is powered up, and O2 heater is off .
- Set Condition:
Desired state does not equal Actual state. One Trip Fault. Three good trips to turn off the MIL .
Possible Causes
(K299) O2 1/2 HEATER CONTROL CIRCUIT OPEN
(Z42) O2 1/2 HEATER GROUND CIRCUIT OPEN
(K299) O2 SENSOR 1/2 HEATER CONTROL CIRCUIT SHORTED TO BATTERY VOLTAGE
O2 SENSOR
PCM
Always perform PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding.