DTC P0031: O2 Sensor 1/1 Heater Circuit Low: Notes
For a complete wiring diagram, refer to SYSTEM WIRING DIAGRAMS .
- When Monitored:
Battery voltage above 10.6 volts, ASD is powered up, and O2 heater is powered .
- Set Condition:
Desired state does not match Actual state. One Trip Fault. Three good trips to turn off the MIL .
Possible Causes
(K99) O2 SENSOR 1/1 HEATER CONTROL CIRCUIT SHORTED TO GROUND
O2 SENSOR
PCM
Always perform PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding.