LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2006 >> Raider XLS, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine And Emission Control >> Canister - Vapor >> Installation

Canister - Vapor: Installation

Fig 1: Removing/Installing Plastic Mounting Clip
G04284123Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Guide the two plastic canister locating pins into the two rubber grommets.
  2. Install pin (3). Press down on pin (3).
  3. Install all vapor hoses and lines to both the EVAP canister and NVLD pump.
  4. The vapor/vacuum lines and hoses must be firmly connected. Also check the vapor/vacuum lines at the NVLD pump, NVLD filter and EVAP canister purge solenoid for damage or leaks. If a leak is present, a Diagnostic Trouble Code (DTC) may be set  .
  5. Install plastic shield in front of left-rear tire.
  6. Install left-rear tire.