LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2006 >> Raider XLS, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Electronic Control Modules >> Diagnosis And Testing >> DTC B2113: 5 Volt Supply Circuit High >> Diagnostic Test

Diagnostic Test

  1. CHECK FOR ACTIVE DTC 
    1. With the scan tool, read the active DTC's.
    2. Cycle the ignition switch from off to on, leaving the ignition on for a minimum of 90 seconds.
    3. With the scan tool, read the active DTC's.

    Q: Does the scan tool display this DTC as active? 

    Yes  :

    • Go To 2

    No  :

    • If the DTC is stored, check for an intermittent condition. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
  2. A/C PRESSURE TRANSDUCER 
    1. Turn the ignition off.
    2. Disconnect the A/C Pressure Transducer harness connector.
    3. Cycle the ignition switch from off to on, leaving the ignition on for a minimum of 90 seconds.
    4. With the scan tool, read the active DTC's.

    Q: Does the scan tool display this DTC as active? 

    Yes  :

    • Go To 3

    No  :

  3. SHIFT MOTOR/MODE SENSOR ASSEMBLY (IF EQUIPPED) 
    1. Turn the ignition off.
    2. Disconnect the Shift Motor/Mode Sensor Assembly harness connector.
      NOTE: If the vehicle is not equipped with this assembly, answer yes to the question.
    3. Cycle the ignition switch from off to on, leaving the ignition on for a minimum of 90 seconds.
    4. With the scan tool, read the active DTC's.

    Q: Does the scan tool display this DTC as active? 

    Yes  :

    • Go To 4

    No  :

  4. (T103) 5 VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE 
    Fig 1: Measuring Voltage Of (T103) 5 Volt Supply Circuit
    G04283794Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    1. Turn the ignition off.
    2. Disconnect the FCM C1 harness connector.
    3. Turn the ignition on.
    4. Measure the voltage of the (T103) 5 Volt Supply circuit.

    Q: Is the voltage above 5.5 volts? 

    Yes  :

    No  :