Diagnostic Test
- TEST FOR INTERMITTENT CONDITION
- Turn the ignition on.NOTE: Ensure the IOD fuse is installed and battery voltage is between 10.0 and 16.0 volts.
- With the scan tool, select ECU view.NOTE: A red X will be next to the module that is not communicating, indicating that the module is not active on the Bus network. A green check indicates that the module is active on the Bus network.
Q: Does the scan tool display a red X next to the module?
Yes :
- Go To 2
No :
- The no response condition is not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring for chafed, pierced, pinched, and partially broken wires and the wiring harness connectors for broken, bent, pushed out, and corroded terminals.
- Turn the ignition on.
- (A924) (A920) (A117) FUSED B(+) CIRCUITS OPEN OR SHORTED
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
- Turn the ignition off.NOTE: Check IPM fuses before continuing.
- Disconnect the Cluster harness connectors.
- Using a 12-volt test light connected to ground, check each (A924) (A920) (A117) Fused B(+) circuit.
Q: Does the test light illuminate brightly for each circuit?
Yes :
- Go To 3
No :
- Repair the (A924) (A920) (A117) Fused B(+) circuit for an open or short.
- Perform BODY VERIFICATION TEST - VER 1 . (Refer to DIAGNOSIS AND TESTING ).
- Turn the ignition off.
- (Z946) (Z948) GROUND CIRCUITS OPEN
- Using a 12-volt test light connected to 12-volts, check each (Z946) (Z948) ground circuit.
Q: Does the test light illuminate brightly for each circuit ?
Yes :
- Go To 4
No :
- Repair the (Z946) (Z948) ground circuit for an open.
- Perform BODY VERIFICATION TEST - VER 1 . (Refer to DIAGNOSIS AND TESTING ).
- (F21) (F983) FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN OR SHORTED
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
- Turn the ignition on.NOTE: Check IPM fuses before continuing.
- Using a 12-volt test light connected to ground, check each (F21) (F983) Fused Ignition Switch Output circuit.NOTE: The ignition must be in the start position to properly check the F21 circuit.
Q: Does the test light illuminate brightly for each circuit?
Yes :
- Go To 5
No :
- Repair the (F21) (F983) Fused Ignition Switch Output circuit for an open or short.
- Perform BODY VERIFICATION TEST - VER 1 . (Refer to DIAGNOSIS AND TESTING ).
- Turn the ignition on.
- (D55) AND (D54) CAN B BUS CIRCUITS OPEN
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
NOTE: One open circuit will not cause this condition.- Measure the voltage between the (D54) CAN B Bus (-) circuit and ground.
- Measure the voltage between the (D55) CAN B Bus (+) circuit and ground.
Q: Is there any voltage present on either circuit?
Yes :
- Replace the Instrument Cluster in accordance with the service information.
- Perform BODY VERIFICATION TEST - VER 1 . (Refer to DIAGNOSIS AND TESTING ).
No :
- Repair the (D55) and (D54) CAN B Bus circuits for an open. Inspect the connector for damage.
- Perform BODY VERIFICATION TEST - VER 1 . (Refer to DIAGNOSIS AND TESTING ).