LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2006 >> Raider XLS, RWD >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Injection >> Cable - Throttle Control >> Installation >> 3.7L V-6

3.7L V-6

Fig 1: Installing Plastic Cable Mount Into Bracket
G04283780Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Slide accelerator cable plastic mount into throttle body mounting bracket. Continue sliding until release tab (2) is aligned to hole in mounting bracket.
    Fig 2: Sliding Throttle Cable Pin Into Throttle Body Bellcrank
    G04283781Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Hold throttle in wide open position. While held in this position, slide throttle cable pin (1) into throttle body bellcrank.
  3. Push cable housing into rubber grommet and through opening in dash panel.
    Fig 3: Identifying Throttle Control Cable & Accelerator Pedal Assembly
    G04283782Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. From inside vehicle, install metal clip holding cable to the dash panel.
  5. From inside vehicle, slide throttle cable core wire into opening (slot) in top of pedal arm.
  6. Push plastic cable retainer (clip) (2) into pedal arm opening until it snaps in place.
  7. Install air resonator tube to throttle body.
  8. Before starting engine, operate accelerator pedal to check for any binding.