LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2006 >> Raider XLS, RWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Abs Service Information >> HCU (Hydraulic Control Unit) >> Installation

HCU (Hydraulic Control Unit): Installation

Fig 1: Removing/Installing HCU Assembly
G04286301Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
NOTE: If the ABM is being replaced with a new ABM it must be reprogrammed with the use of a scantool.
  1. Reinstall the HCU assembly (5) to the vehicle.
  2. Install HCU assembly (5) on the battery tray (2) and Tighten the nuts to 15 N.m (11 ft. lbs.).
    Fig 2: Connecting Brake Lines To HCU
    G04286302Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Install the brake lines (3) to the HCU (1) and tighten to 19 N.m (170 in. lbs.).
    Fig 3: Removing/Installing HCU Assembly
    G04286303Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Install the electrical harness connector (4) to the ABM (3).
  5. Install the battery cables to the battery.
  6. Bleed ABS brake system (Refer to ABS BRAKE BLEEDING ).