Front Wheel Alignment Check And Adjustment: Toe-In
- Standard value: 0 +/- 3 mm (0 +/- 0.12 inch)
- Adjust the toe-in by undoing the clip and jam nut, and turning the left and right tie rod turnbuckles by the same amount (in opposite directions).NOTE: The toe will move out as the left turnbuckle is turned toward the front of the vehicle and the right turnbuckle is turned toward the rear of the vehicle.
- Install the clip and tighten the jam nut to the specified torque.
- Tightening torque: 52 +/- 2 N.m (38 +/- 2 ft-lb)
- Confirm that the toe-in is at the standard value.
- Use a turning radius gauge to check that the steering angle is at the standard value.
- STEERING ANGLE
- Standard value:
- 35°36' +/- 2°00' < Inner wheel >
- 30° 00' < Outer wheel (reference) >
- On vehicles with ASC, if the toe-in is adjusted, always carry out steering wheel sensor calibration (Refer to STEERING WHEEL SENSOR CALIBRATION ).