LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2005 >> Endeavor LS, AWD >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension & Wheel Alignment >> On-Vehicle Service >> Front Wheel Alignment Check And Adjustment >> Toe-In

Front Wheel Alignment Check And Adjustment: Toe-In

  1. Adjust the toe-in by undoing the clip and jam nut, and turning the left and right tie rod turnbuckles by the same amount (in opposite directions).
    NOTE: The toe will move out as the left turnbuckle is turned toward the front of the vehicle and the right turnbuckle is turned toward the rear of the vehicle.
    Fig 1: Identifying Jam Nut & Clip
    G02412087Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Install the clip and tighten the jam nut to the specified torque.
    • Tightening torque: 52 +/- 2 N.m (38 +/- 2 ft-lb) 
  3. Confirm that the toe-in is at the standard value.
  4. Use a turning radius gauge to check that the steering angle is at the standard value.
    • STEERING ANGLE 
    • Standard value: 
      • 35°36' +/- 2°00' < Inner wheel > 
      • 30° 00' < Outer wheel (reference) > 
  5. On vehicles with ASC, if the toe-in is adjusted, always carry out steering wheel sensor calibration (Refer to STEERING WHEEL SENSOR CALIBRATION ).