Additional Key Registration Method
Additional keys can be registered to the system without the use of special tools, provided that there are two valid encrypted keys available to initiate the procedure.
- Insert the first valid key into the ignition and turn the ignition to the "ON" position for 5 seconds.
- Turn the ignition to the "OFF" position and remove the first key.
- Insert the second valid key and switch the ignition to the "ON" position within 7 seconds. The theft-alarm indicator will blink twice.
- Turn the ignition to the "OFF" position and remove the second key.
- Insert a blank Sentry Key into the ignition and switch the ignition to the "ON" position within 7 seconds.
- The theft-alarm indicator will illuminate for about 3 seconds when registration is complete. If an error occurs, the indicator will flash 3 times.
- Repeat step 5 if you wish to register additional keys. Be sure to complete the entire registration procedure within 30 seconds after the theft-alarm indicator flashed in step 3
CAUTION:
Because registering keys by this method does not alter the original key ID it is recommended that the encrypted code registration method be used when replacing keys due to theft or loss.