LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2003 >> Eclipse RS, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics - 2.4L >> Diagnostic Tests >> DTC P0441: EVAP System Incorrect Purge Flow >> Diagnostic Procedure

Diagnostic Procedure

CAUTION: To prevent damage to scan tool (MB991502), always turn the ignition off before connecting or disconnecting it.
  1. Connect scan tool (MB991502) to the data link connector. Turn the ignition on. Read the DTC. Turn the ignition off. If DTC P0451 is output, refer to DTC P0451: EVAP SYSTEM PRESSURE SENSOR MALFUNCTION  . If the DTC is absent, go to the next step.
  2. Turn the ignition on. Remove the fuel cap. Set the scan tool to data reading mode for item 73, Fuel Tank Differential Pressure Sensor. The fuel tank differential pressures should be -1.5 to 1.5 kPa. Turn the ignition off. If the solenoid is operating properly, go to the next step. If the solenoid is malfunctioning, refer to DTC P0451: EVAP SYSTEM PRESSURE SENSOR MALFUNCTION  .
  3. Turn the ignition on. Set the scan tool to actuator test mode for item 08, Evaporative emission purge solenoid. An operation sound should be heard and vibration should be felt when the evaporative emission purge solenoid is operated. Turn the ignition off. If the solenoid is operating properly, go to the next step. If the solenoid is malfunctioning, replace the evaporative emission purge solenoid and proceed to step  5 .
  4. Turn the ignition on. Set the scan tool to actuator test mode for item 29, Evaporative emission ventilation solenoid. An operation sound should be heard and vibration should be felt when the evaporative emission ventilation solenoid is operated. Turn the ignition off. If the solenoid is operating properly, repair or replace the vent hose and air filter. If the solenoid is malfunctioning, replace the evaporative emission ventilation solenoid. Go to the next step.
  5. Carry out a test drive with the drive cycle pattern, refer to EVAP SYSTEM LEAK MONITOR  . Read the diagnostic trouble codes. If DTC P0441 is set, retry the troubleshooting. If the DTC is absent, the inspection is complete.