LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2000 >> Diamante ES >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Component Tests >> Vehicle Speed Sensor Test

Vehicle Speed Sensor Test

  1. Remove vehicle speed sensor from transaxle. See VEHICLE SPEED SENSOR  under REMOVAL & INSTALLATION. Using a 3000-10,000 ohm resistor, connect resistor between sensor terminals No. 1 (Black/White wire) and No. 3 (White/Blue wire). Connect battery voltage to sensor terminal No. 1 (Black/White wire) and ground terminal No. 2 (Black wire). See Fig 1 .
  2. Connect an analog voltmeter between sensor terminals No. 2 (Black wire) and No. 3 (White/Blue wire). Manually turn sensor shaft. Voltmeter needle should deflect, reading voltage (one turn equals 4 pulses). Replace sensor if pulses are not read.
    Fig 1: Connections For Testing Vehicle Speed Sensor
    G99D05099Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.