LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2000 >> Diamante ES >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Multiplex Control Systems >> System Tests >> Test No. 6

Test No. 6

Symptoms indicate problem with ignition switch circuit to instrument panel ECU. A malfunction in ignition switch input circuit causes specification confirmation code of each unit to be displayed. Probable causes are wiring, connector, or instrument panel ECU malfunction.

  1. Enter specification confirmation mode. See RETRIEVING DIAGNOSTIC TROUBLE CODES (DTC)  under SELF-DIAGNOSTIC SYSTEM. Check if specification code is displayed correctly when ignition is off. If specification code is displayed correctly, go to next step. If specification code is not displayed correctly, check fuse No. 9 (10-amp) and Blue/Red wire between ETACS-ECU and ignition switch. Repair as necessary.
  2. Turn ignition on. Check if scan tool changes to DTC display mode. If simplified fault diagnostic mode changes as specified, go to next step. If simplified fault diagnostic mode does not change as specified, check for open in Red/Blue wire between instrument panel ECU 22-pin connector B-23 terminal No. 9 and engine compartment relay box fuse No. 13 (15-amp). Check for open in Black/White wire between instrument panel 16-pin connector C-10 terminal No. 41 and junction block fuse No. 13 (10-amp). Repair as necessary.
  3. Check if DTC 29, 34, 41 or 51 is present. If any specified DTCs are present, diagnose fault. See SELF-DIAGNOSTIC SYSTEM  . If no specified DTCs are present, replace instrument panel ECU.