Test No. 5
Symptom indicates problem with ignition switch input circuit to instrument panel ECU, multiplex communications line fault, or ETACS-ECU buzzer malfunction. Probable causes are wiring, connector, instrument panel ECU or ETACS-ECU malfunction.
- Check ETACS-ECU buzzer operation. If buzzer operates, go to next step. If buzzer does not operate, check ignition switch. See IGNITION SWITCH under COMPONENT TESTS.
- Put multiplex system in simplified fault diagnostic mode using scan tool or non-scan tool procedure. See RETRIEVING DIAGNOSTIC TROUBLE CODES (DTC) under SELF-DIAGNOSTIC SYSTEM. If using scan tool, go to next step. If not using scan tool, turn ignition switch to ACC position. High beam indicator light should flash and buzzer should sound. Turn ignition switch to ON position. High beam indicator light should flash and buzzer should sound. If system responds as indicated, go to step 5 . If system does not respond as indicated, go to step 4 .
- Using scan tool, select service data. Refer to scan tool manufacturer's instructions. After selecting service data, select the following items and operate appropriate switches:
- Item No. 28 (ignition switch ACC).
- Item No. 27 (ignition switch IG1).
- Item No. 26 (ignition switch IG2).
- Check junction block fuses No. 9 (10-amp) and No. 15 (10-amp). Check Blue/Red wire between ETACS-ECU and ignition switch. Repair as necessary.
- Turn ignition on. Measure voltage (backprobe) between ground and instrument panel ECU connector C-10 terminal No. 41 (Black/White wire). If battery voltage is present, go to next step. If battery voltage is not present, check junction block fuse No. 13 (10-amp). Check Black/White wire between instrument panel ECU and junction block. Repair as necessary.
- Using simplified diagnostic mode, check if DTC 29, 34, 41 or 51 is output. If any specified DTCs are present, diagnose fault. See SELF-DIAGNOSTIC SYSTEM . If no specified DTCs are present, replace instrument panel ECU.