LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2000 >> Diamante ES >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Multiplex Control Systems >> System Tests >> Test No. 4

Test No. 4

Symptom indicates problem with ignition switch input circuit to instrument panel ECU or multiplex communications line fault. Probable causes are wiring, connector, or instrument panel ECU malfunction.

  1. Put multiplex system in simplified fault diagnostic mode. See RETRIEVING DIAGNOSTIC TROUBLE CODES (DTC)  under SELF-DIAGNOSTIC SYSTEM. If using scan tool, go to next step. If not using scan tool, turn ignition switch to ACC position. High beam indicator light should flash and buzzer should sound. Turn ignition switch to ON position. High beam indicator light should flash and buzzer should sound. If system responds as indicated, go to step  4 . If system does not respond as indicated, go to step  3 .
  2. Using scan tool, select service data. Refer to scan tool manufacturer's instructions. After selecting service data, select the following items and operate appropriate switches:
    • Item No. 28 (ignition switch ACC).
    • Item No. 27 (ignition switch IG1).
    • Item No. 26 (ignition switch IG2).
    If scan tool indicates correct switch operation, go to step  4 . If scan tool does not indicate correct switch operation, go to next step.
  3. Check junction block fuse No. 13 (10-amp). Check for open or short in Black/White wire between instrument panel ECU and ignition switch. Repair as necessary.
  4. Using simplified diagnostic mode, check if DTC 29, 34, 41 or 51 is output. If any specified DTCs are present, replace instrument panel ECU. If any DTC other than ones specified are present, diagnose fault. See SELF-DIAGNOSTIC SYSTEM  .