LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2000 >> Diamante ES >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Multiplex Control Systems >> System Tests >> Test No. 3

Test No. 3

Symptom indicates problem with diagnostic control terminal grounding or malfunction in vehicle speed sensor signal. Probable causes are vehicle speed sensor, wiring, connector, or instrument panel ECU malfunction.

  1. Connect scan tool to DLC. Measure voltage between ground and instrument panel connector B-23 terminal No. 16 (Gray/Red wire) by backprobing. If voltage reading is zero volts, go to next step. If voltage reading is not zero volts, locate and repair short to ground in Gray/Red wire between DLC and instrument panel ECU. See WIRING DIAGRAMS in INSTRUMENT PANELS - DIAMANTE article. Repair as necessary.
  2. Check speedometer operation. If speedometer is operating normally, go to next step. If speedometer is not operating normally, check vehicle speed sensor. See VEHICLE SPEED SENSOR  under COMPONENT TESTS.
  3. Check White/Blue wire between vehicle speed sensor and instrument panel ECU. Repair as necessary. If White/Blue wire is okay, replace instrument panel ECU.