LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2000 >> Diamante ES >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Multiplex Control Systems >> System Tests >> Test No. 2

Test No. 2

Symptom indicates problem with diagnostic control terminal input circuit or problem with light switch. Probable causes are light switch, wiring, connector, or instrument panel ECU malfunction.

  1. Check light switch operation. Turn headlights on. Operate high and low beams. Turn headlights off. Operate passing switch. If headlights operate properly, go to next step. If headlights do not operate properly, go to step  3 .
  2. Check connectors and Gray/Red wire between DLC terminal No. 1 and instrument panel ECU 22-pin connector terminal No. 16. Repair as necessary. If connectors and Gray/Red wire are okay, replace instrument panel ECU.
  3. Check steering column light switch. See STEERING COLUMN LIGHT SWITCH  under COMPONENT TESTS. Replace as necessary. If switch is okay, go to next step.
  4. Disconnect instrument panel ECU 22-pin connector B-23. Measure voltage between ground and instrument panel ECU connector B-23 terminal No. 9 (Red/Blue wire). If battery voltage is present, go to next step. If battery voltage is not present, repair Red/Blue wire between engine compartment relay box fuse No. 13 (15-amp) and instrument panel ECU.
  5. Disconnect instrument panel ECU 16-pin connector C-10. Measure voltage between ground and instrument panel ECU connector C-10 terminal No. 41 (Black/White wire). If battery voltage is present, go to next step. If battery voltage is not present, repair Black/White wire between junction block fuse No. 13 (10-amp) and instrument panel ECU.
  6. Check continuity between ground and instrument panel ECU connector B-23 terminal No. 21 (Black wire). See WIRING DIAGRAMS in INSTRUMENT PANEL - DIAMANTE article. If continuity is present, go to next step. If continuity is not present, repair Black wire between instrument panel ECU and ground.
  7. Check continuity between ground and instrument panel ECU connector C-10 terminal No. 39 (Black wire). If continuity is present, replace instrument panel ECU. If continuity is not present, repair Black wire between instrument panel ECU and ground.