Diagnostic Procedure
NOTE:
For terminal identification, see
TERMINAL IDENTIFICATION in SELF-DIAGNOSTICS - INTRODUCTION article. For circuit and wire color identification, see
WIRING DIAGRAMS article.
- If using scan tool, go to next step. If using lab scope, go to step 3.
- Using scan tool, read data list item No. 45 (idle air control position sensor step). See IAC POSITION SENSOR STEP SPECIFICATIONS table. If scan tool does not read as specified, replace IAC position sensor. If readings are as specified, go to step 5.IAC POSITION SENSOR STEP SPECIFICATIONS
A/C Switch Position Step Value Off 2-25 Off To On Increase From 10-70 (1) Increase From 5-50 (1) Brakes applied. A/C off on Montero. A/C on on 3000GT. Move gear selector lever from Neutral to Drive. NOTE: Check wave pattern when idle speed increases when A/C is turned on. Wave pattern display lasts less than one second. - Install special Test Harness (MD998463) between IAC motor connector component side and harness side, or backprobe at connector. Using lab scope, connect pick-up in sequence to IAC motor connector terminals No. 1 (Red clip), No. 3 (Green clip), No. 4 (Black clip) and No. 6 (Yellow clip), or ECM terminals No. 14, 28, 15 and 29, respectively. Start engine and allow it to idle. Turn A/C on. Compare oscilloscope wave pattern with known-good wave pattern. See Fig 1. Turn engine off. If wave pattern is not normal, go to next step. If wave pattern is normal, fault is intermittent. For trouble shooting, see INTERMITTENT DTCS under CIRCUIT TESTS.
- Disconnect IAC motor connector. Using DVOM, check resistance between IAC connector terminals No. 2 (White clip) and either terminal No. 1 (Red clip) or No. 3 (Blue clip), and between IAC connector terminals No. 5 (Green clip) and either terminal No. 4 (Black clip) or No. 6 (Yellow clip). Resistance should be 28-33 ohms at 68°F (20°C). If resistance is as specified, go to next step. If resistance is not as specified, replace IAC motor. Go to step 9.
- On 3000GT, go to step 7. On Montero, disconnect IAC motor connector and MFI relay connector. Check for continuity between IAC motor connector terminal No. 2 and MFI relay connector terminal No. 1. If continuity does not exist, repair wiring harness as necessary. If continuity exists, go to next step.
- Check for continuity between IAC motor connector terminal No. 5 and MFI relay connector terminal No. 1. If continuity does not exist, repair wiring harness as necessary. If continuity exists, go to next step.
- Disconnect IAC motor connector. Turn ignition switch to ON position. Check voltage between chassis ground and IAC motor connector terminals No. 2 and 5. If battery voltage does not exist on either circuit, repair wiring harness as necessary. If battery voltage exists on both circuits, go to next step.
- Turn ignition switch to OFF position. Disconnect ECM connector and IAC motor connector. Ground specified ECM connector terminal and using DVOM, check continuity between chassis ground and specified IAC motor connector terminal. See ECM-TO-IAC MOTOR HARNESS CIRCUIT IDENTIFICATION table. If continuity does not exist, repair wiring harness as necessary, and then go to next step. If continuity exists, problem is intermittent. For trouble shooting, see INTERMITTENT DTCS .ECM-TO-IAC MOTOR HARNESS CIRCUIT IDENTIFICATION
ECM Terminal No. IAC Motor Terminal No. 14 1 15 4 28 3 29 6 - Test drive vehicle following OBD-II drive cycle pattern. See OTHER MONITOR under OBD-II DRIVE CYCLES in SELF-DIAGNOSTICS - INTRODUCTION article. Check scan tool for DTCs. Confirm DTC does not reset.