LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1999 >> 3000GT Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Self-Diagnostic System >> Retrieving Input Switch Codes

Retrieving Input Switch Codes

NOTE: System input switch test should be performed if no trouble codes are stored when performing self-diagnostics. System input tests cycle each cruise control switch and sensor.
  1. Use scan tool or an analog voltmeter for code retrieval. Turn ignition off. Install scan tool/voltmeter. Turn ignition on. While holding cruise control switch in SET position, turn cruise control main switch on. Within one second, move cruise control switch to RESUME position.
  2. Operate each switch listed in CHECK RESULTS CODE IDENTIFICATION  table, and read input switch codes on scan tool or voltmeter. Repair or replace components as necessary.
CHECK RESULTS CODE IDENTIFICATION

Code Input Operation
21 SET Switch ON
22 RESUME Switch ON
23 Brakelight/Stoplight Switch ON (Brake Pedal Depressed)
24 Vehicle Speed Signal At 25 MPH Or Greater
25 Vehicle Speed Signal Below 25 MPH
26 P/N Switch ON With Lever In "N" Range (A/T) Or Clutch Pedal Position Switch (M/T) ON
27 CANCEL Switch ON
28 Throttle Position (TP) Sensor Voltage At 1.5 Volt Or More
29 Closed Throttle Position Switch Is OFF