Cruise Control Main Switch Test
- Remove cruise control main switch from instrument panel. Disconnect main switch harness connector. Check continuity between specified switch terminals. See CRUISE CONTROL MAIN SWITCH TEST table. Replace as necessary.
- To test illumination light, connect battery positive to terminal No. 3 and battery negative to terminal No. 4. With switch held in ON position, battery voltage should be present and light should glow. If switch does not test as specified, replace main switch.
CRUISE CONTROL MAIN SWITCH TEST
| Application & Terminal No. | Condition | |
|---|---|---|
| OFF Position (2 & 6) | Continuity | |
| NEUTRAL Position | ||
| 2 & 6 | Continuity | |
| 1 & 4 | Continuity | |
| ON Position | ||
| 1 & 3 | Continuity | |
| 1 & 4 | Continuity | |
| 2 & 6 | Continuity | |