LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1995 >> Diamante Base >> Repair and Diagnosis >> Body & Frame >> Mirrors - Power >> Component Testing >> Input Signal

Input Signal

NOTE: If after all testing has been completed, power mirror is still not functioning, substitute ETACS unit with known good unit and retest.
  1. Access Data Link Connector (DLC) at lower left corner of dash. Using Special Tool (MB991529), connect positive lead of analog voltmeter to terminal No. 9 and negative lead to terminal No. 4 or 5. SeeFig 1 . Check if input signals from power mirror switch are being received by ETACS module.
  2. Voltmeter needle should sweep when each switch is operated. If switch or related component is not functioning, voltmeter will not operate when switch is activated. Check related circuit and/or component.
Fig 1: Identifying Data Link Connector Terminals
G94D46295Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.