LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1994 >> Galant ES >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Diagnostic Testing >> Code 41-48: Solenoid Valve

Code 41-48: Solenoid Valve

NOTE: Codes 41-48 will be output if the ABS ECU detects a short or open in solenoid valve harness or solenoid coil.
  1. Ensure ignition is off. Disconnect hydraulic unit 10-pin and 2-pin (square connector) harness connectors. Using ohmmeter, measure resistance between terminals No. 31 and 32 of 2-pin component connector and each terminal of 10-pin component connector except terminals No. 5 and 10. See Figure .
  2. If resistance of any circuit is not 5.5-6.5 ohms, replace hydraulic unit and retest. See HYDRAULIC UNIT under REMOVAL & INSTALLATION. If resistance is within specification, go to next step.
  3. Disconnect ABS ECU harness connector. Check continuity of circuits between ECU and hydraulic unit. See WIRING DIAGRAM. If continuity does not exist in any circuit, inspect and repair suspected circuit(s) as needed.
  4. If continuity exists in all circuits, turn ignition on. Using DVOM, measure voltage between ECU harness connector terminal No. 43 and ground. See Figure . If battery voltage is present, replace ABS ECU and retest.
  5. If battery voltage is not present, inspect and repair power supply circuit from fuse No. 8 and ECU terminal No. 43, including in-line diode. See Figure . See WIRING DIAGRAM.