Code 32: Pedal Stroke Sensor (PSS)
NOTE:
Code 32 is output if vehicle acceleration (or deceleration) is above specified value with respect to pedal stroke sensor input voltage for at least 10 seconds or more. Code will also be output if input voltage is above specified value for 15 seconds or more.
- Inspect PSS installation. See PEDAL STROKE SENSOR under REMOVAL & INSTALLATION. Adjust as needed. Inspect PSS operation. See PEDAL STROKE SENSOR under COMPONENT TESTING. Replace sensor as needed.
- Ensure ignition is off. Disconnect ABS ECU harness connector C-64. Using ohmmeter, check continuity between harness connector terminal No. 7 and ground. If continuity does not exist, repair circuit as needed. See WIRING DIAGRAM. If continuity exists, replace ECU and retest system.