LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1988 >> Precis Base >> Repair and Diagnosis >> Transmission >> Clutches >> Removal & Installation >> Clutch Assembly >> Inspection

Clutch Assembly: Inspection

  1. Check release bearing and release fork for damage or wear. DO NOT clean bearing assembly in solvent. Inspect clutch cable for or signs of fraying. Check cable for rough movement. Inspect hydraulic system components for fluid leakage and cylinder dust boot for cracks or deterioration.
  2. Inspect pressure plate surface for wear, cracks, and/or discoloration. Check strap plate rivets and replace assembly if loose. Measure diaphragm spring ends for wear and uneven height. Replace assembly if difference between fingers exceed .02" (5 mm).
  3. Check clutch disc facing for loose rivets, uneven contact, deterioration, seizure or oil saturation. Measure disc thickness or rivet sink limit. Replace disc if not within specifications. See CLUTCH DISC THICKNESS SPECIFICATIONS  table. Replace worn or defective components as necessary.
CLUTCH DISC THICKNESS SPECIFICATIONS

Application In. (mm)
Disc Thickness
Mirage (1) .30-.32 (7.6-8.1)
Cordia, Galant & Tredia .33-.35 (8.4-8.9)
Precis (2)
(1) On 1.6L engine thickness is .31-.34" (7.9-8.6 mm).
(2) Rivet sink limit is .012" (0.3 mm).