LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1987 >> Starion ESI-R >> Repair and Diagnosis >> Maintenance >> Procedures >> Maintenance Reminder Light (Reset Procedures) >> Tire Pressure Monitor System Reminder >> TPMS Reminder Reset - Procedure 01

TPMS Reminder Reset - Procedure 01

NOTE: If a TPM system tire pressure sensor, receiver, antenna or feeder cable(s) is replaced, the tire pressure sensors must be registered.

The following tools are used to register TPM system:

CAUTION: To prevent damage to Scan Tool (MB991958), always turn ignition switch to OFF position before connecting or disconnecting scan tool.
  1. Connect scan tool to Data Link Connector (DLC). See Figure.
  2. Turn ignition switch to ON position.
  3. Select "INTERACTIVE DIAGNOSIS" from start-up screen.
  4. Select "SYSTEM SELECT".
  5. Choose "TPMS" from "CHASSIS" tab.
  6. Select "MITSUBISHI".
  7. Select "SPECIAL FUNCTION".
  8. Select "TIRE PRESSURE SENSOR ID REGISTRATION".
    NOTE: Register all tire pressure sensor ID's within 5 minutes.
  9. Select "5TIRES PRES SNSR ID REGISTRATION (NORMAL SPARE TIRE)" or "4TIRES PRES SNSR ID REGISTRATION (COMPACT SPARE TIRE)" and start tire pressure sensor ID registration.
  10. NOTE: The following operations may be started from any tire pressure sensor. The sensor ID registration has no order.
    NOTE: If sensor is not activated, slide magnet until it is activated. If sensor is still not activated, move vehicle (turn the tire) by approximately half a turn of the tire. Then attempt to activate sensor.
  11. Emit signal from a tire pressure sensor as follows:
    • Clean tire pressure sensor location on wheel rim.
    • Position TPMS Magnet (MIT46716) or a strong magnet as shown, and hold it there for 5 seconds or more. See Fig 1. The reed switch (incorporated in tire pressure sensor) will activate sensor to send tire pressure sensor ID.
  12. Using scan tool, ensure sensor is activated.
  13. Repeat steps  8- 10 for all sensor-fitted tires (including spare tire).
    NOTE: If the spare tire pressure sensor ID cannot be registered, bring the spare tire near one of the road tires. Then register the tire pressure sensor ID. There is no TPMS antenna for the spare tire, so this work helps the road tire TPMS antenna receive signal from the spare tire securely.
    NOTE: If the spare tire is removed, always reposition valve. See Fig 2. If valve is not positioned as shown, the system may determine the spare tire as a road tire incorrectly.
  14. Check completion of the tire pressure sensor ID registration (display on screen).
  15. After tire pressure sensor ID registration, turn ignition switch to OFF position. Remove scan tool. Ensure warning light does not illuminate or flash.
  16. Fig 1: Positioning TPMS Magnet (MIT46716)
    G00225530Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Positioning Valve On Spare Tire
    G00225531Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.