LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2014 >> Cooper Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Quick Lookups >> Technical Bulletins >> Technical Service Bulletins >> Other Variant >> Engine Control Systems >> Various Check Control Messages With Fault 11B033 Stored In DME (M12 08 14)

Various Check Control Messages With Fault 11B033 Stored In DME (M12 08 14)

WARNING: This page is about the Cooper Base, 2D Hatchback, Automatic Trans, which is a different variant/trim than selected.
Publication date: 2014-07-01
Reference number: M12 08 14

VARIOUS CHECK CONTROL MESSAGES WITH FAULT 11B033 STORED IN DME

VARIOUS CHECK CONTROL MESSAGES WITH FAULT 11B033 STORED IN DME

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI M12 08 14, Date of Issue:  July 2014
MINI: F56 (Cooper and Cooper S Hardtop); With B38M and B48M engines produced to 7/1/2014
GROUP: Engine Electrical Systems

SUBJECT

Various Check Control Messages with Fault 11B033 Stored in DME 

SITUATION

A drivetrain or MSA malfunction Check Control message may be displayed, along with a Service Engine Soon light (MIL).

DME fault 11B033: Fuel pump control module (FPC), signal: Short circuit to ground is stored in the DME.

CAUSE

Unfavorable DME software diagnostics

PROCEDURE

By itself, the fault entry, 11B033: Fuel pump control module (FPC), signal: Short circuit to ground, does not trigger a Check Control message. It is caused by another fault code in the DME memory: see SI  M12 04 14  . 

Perform a vehicle test and work though the recommended test plans for all other faults.

It is possible to determine if DME fault 11B033 is either an actual error or false (software) by performing the following steps:

Program the vehicle using the latest version of ISTA/P.

Target integration level: R056-14-07-500 or higher

For information on programming and coding with ISTA/P, refer to CenterNet/Aftersales Portal/Service/Workshop Technology/Vehicle Programming.

Always connect a MINI approved battery charger/power supply (SI  M04 08 09  ). 

WARRANTY INFORMATION

Covered under the terms of the MINI New Passenger Car Limited Warranty or the MINI NEXT Certified Pre-Owned Limited Warranty.

WARRANTY INFORMATION

Defect Code:  16 14 06 02 00 
WARRANTY INFORMATION

Labor Operation: Labor Allowance: Description:
00 00 006 Refer to KSD2 Performing "vehicle test" (with vehicle diagnosis system - checking faults)
and
61 21 528 Refer to KSD2 Connect an approved battery charger/power supply (indicated in KSD 2 as Charging battery)
and if necessary
61 00 730 Refer to KSD2 Programming/encoding control units

Labor operation code 00 00 006 is a Main labor operation. If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556 instead.

Refer to KSD2 for the corresponding flat rate unit (FRU) allowance. Enter the Chassis Number, which consists of the last 7 digits of the Vehicle Identification Number (VIN). Click on the "Search" button, and then enter the applicable flat rate labor operation in the FR code field.

If control module(s) fail to reprogram or initializations are required, the additional work must be claimed using separate labor operations found in KSD2 under the defect code listed above.

Other Repairs

If performing ISTA diagnostics and related test plans results in other eligible and covered work, claim this work with the applicable defect code and/or labor operations listed in KSD2.