LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2014 >> Cooper Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Quick Lookups >> Technical Bulletins >> Technical Service Bulletins >> Other Variant >> Engine Control Systems >> Communication Fault For Electric Fan (SI M12 07 16)

Communication Fault For Electric Fan (SI M12 07 16)

WARNING: This page is about the Cooper Base, 2D Hatchback, Automatic Trans, which is a different variant/trim than selected.
Publication date: 2016-11-01
Reference number: SI M12 07 16

COMMUNICATION FAULT FOR ELECTRIC FAN

COMMUNICATION FAULT FOR ELECTRIC FAN

TECHNICAL SERVICE BULLETIN

Reference Number(s): SI M12 07 16, Date of Issue:  November 2016
MINI: F56 (Hardtop); F55 (Hardtop 4 Door); Produced to October 31, 2015
GROUP: Engine Electrical Systems

SITUATION

The Service Engine Soon light is on with the following fault code stored in the DME:

CAUSE

DME software calibration

CORRECTION

Update the DME with the latest version of ISTA/P.

PROCEDURE

Program the vehicle using the latest version of ISTA/P (3.59.0 or higher).

Target integration level: F056-15-11-500 or higher 

For information on programming and coding with ISTA/P, refer to CenterNet/Aftersales Portal/Service/Workshop Technology/Vehicle Programming.

Always connect a MINI approved battery charger/power supply  (SI M04 08 09  ).

NOTE: Perform the appropriate diagnostic test plan in ISTA if the fault code is stored and I Level is already at F056-15-11-500 or higher or the fault will not clear after programming.

WARRANTY INFORMATION

Covered under the terms of the MINI New Passenger Car Limited Warranty or the MINI NEXT Certified Pre-Owned Limited Warranty.

WARRANTY INFORMATION

Defect Code: 1711119900
Labor Operation: Labor Allowance: Description:
00 00 006 Refer to KSD2 Performing "vehicle test" (with vehicle diagnosis system - checking faults) (Main work)
Or:
00 00 556 Refer to KSD2 Performing "vehicle test" (with vehicle diagnosis system - checking faults) (Plus work)
And:
61 21 528 Refer to KSD2 Connect an approved battery charger/power supply (indicated in KSD 2 as Charging battery)
And:
61 00 730 Refer to KSD2 Programming/encoding control unit(s)

If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556 instead.

Refer to KSD2 for the corresponding flat rate unit (FRU) allowances.

Vehicle Programming and Coding

When ISTA/P automatically reprograms and codes all the vehicle control modules that currently do not have the latest software and control module failures occur during this programming:

  • Please claim these consequential control module repair work under the defect code listed in this bulletin with the applicable KSD2 labor operations.

Other Repairs

Control module failures that occurred prior to this programming:

  • When covered under an applicable limited warranty, claim these control module repairs using the applicable defect code and labor operations in KSD2.