LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1006 (Seating) >> Removal And Installation >> Heated Seat Module >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Milan, 2008 Lincoln MKZ, and 2008 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The air bag warning indicator illuminates when the correct restraints control module (RCM) fuse is removed and the ignition switch is ON.
NOTE: The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
  1. Remove the front passenger seat. For additional information, refer to Seat - Front .
  2. Remove the heated seat module from the cushion electrical bracket.
    • Disconnect the heated seat module electrical connector.
    • Remove the rivet and heated seat module.
  3. To install, reverse the removal procedure.
  4. Install the front passenger seat and repower the SRS. Do not prove out the SRS at this time.  For additional information, refer to Seat - Front .
  5. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test. For additional information, refer to the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM article.