LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2007 >> Milan Base, 3.0 1, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Electronic Engine Controls - 2.3L) >> Removal And Installation >> Catalyst Monitor Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the catalyst monitor sensor (CMS) electrical connector.
  3. NOTE: If necessary, lubricate the sensor threads with penetrating and lock lubricant to assist in removal.
  4. Using the special tool, remove the CMS.
    • To install tighten to 48 Nm (35 lb-ft).
  5. Fig 1: Disconnecting Heated Oxygen Sensor (HO2S) Electrical Connector
    GF0024516Courtesy of FORD MOTOR CO.
    NOTE: Apply a light coat of anti-seize lubricant to the threads of the CMS.
  6. To install, reverse the removal procedure.