LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2006 >> Milan Base, 2.3 Z, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle/Transmission - FNR5 >> In-Vehicle Repair >> Transaxle Support Insulator >> Installation

Transaxle Support Insulator: Installation

  1. Clean the rear transaxle mount bolts using a wire brush and apply new threadlock to the threads.
  2. Position the transaxle mount in place and install the 2 lower bolts.
    • Tighten to 62 Nm (46 lb-ft).
      Fig 1: Locating Transaxle Mount Bolts
      G04681846Courtesy of FORD MOTOR CO.
  3. Position the LH front structure-to-subframe splash shield in place and install the 6 pin-type retainers.
    Fig 2: Locating LH Front Structure-To-Subframe Splash Shield
    G04681847Courtesy of FORD MOTOR CO.
  4. Position the LH splash shield in place and install the 4 screws.
    Fig 3: Locating Splash Shield Screws
    G04681848Courtesy of FORD MOTOR CO.
  5. Install the 2 upper bolts.
    • Tighten to 62 Nm (46 lb-ft).
      Fig 4: Locating Transaxle Insulator Bolts
      G04681849Courtesy of FORD MOTOR CO.
  6. Install the 2 transmission insulator bolts.
    • Tighten to 90 Nm (66 lb-ft).
      Fig 5: Locating Transaxle Insulator Bolts
      G04681850Courtesy of FORD MOTOR CO.
  7. Remove the special tools.
    Fig 6: Identifying Special Tool
    G04681851Courtesy of FORD MOTOR CO.
  8. Install the battery and battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES .