LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2002 >> Cougar 2.5 L, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 2.5L >> In-Vehicle Repair >> Engine Front Cover >> Installation

Engine Front Cover: Installation

  1. Prior to applying silicone gasket and sealant, clean the front cover to cylinder block and cylinder head sealing surfaces.
  2. NOTE: Install the engine front cover within six minutes of applying silicone gasket and sealant.
    Fig 1: Identifying Sealant Locations
    G03418779Courtesy of FORD MOTOR CO.
  3. Apply a 6 mm dot of silicone gasket and sealant to the indicated locations.
  4. NOTE: The engine front cover must be installed in a two Step sequence.
    NOTE: Locating dowels and the locations of the studs.
  5. Install the engine front cover.
    • Use new gaskets.
    • Install the bolts and studs in the indicated sequence and tighten in two steps.
    • First tighten the seven bolts and studs one quarter turn (90 degrees) after the engine front cover contacts the cylinder block and the cylinder heads.
      Fig 2: Installing Engine Front Cover
      G03418780Courtesy of FORD MOTOR CO.
  6. NOTE: Tighten the bolts and studs in the indicated sequence.
    Fig 3: Identifying Engine Cover Bolt & Stud Tightening Sequence
    G03418781Courtesy of FORD MOTOR CO.
  7. Install the remaining bolts and studs.
  8. NOTE: Lightly lubricate the new O-ring seals with engine oil before installation.
    Fig 4: Installing CMP And CKP Sensors
    G03418782Courtesy of FORD MOTOR CO.
  9. Install the CMP and CKP sensors.
  10. Connect the CMP sensor and left hand HO2S electrical connectors.
    • Position the wiring harness and attach the retainer.
      Fig 5: Connecting CMP Sensor And Left Hand HO2S Electrical Connectors
      G03418783Courtesy of FORD MOTOR CO.
  11. Connect the CKP sensor electrical connector and attach the retainer.
    Fig 6: Connecting CKP Sensor Electrical Connector
    G03418784Courtesy of FORD MOTOR CO.
  12. Install the power steering pump. For additional information, refer to POWER STEERING .
  13. Install the generator. For additional information, refer to GENERATORS & REGULATORS article .
  14. Install the oil pan. For additional information, refer to OIL PAN .
  15. Install the right-hand valve cover. For additional information, refer to VALVE COVER - RH .
  16. Install the left-hand valve cover. For additional information, refer to VALVE COVER - LH .