LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2002 >> Cougar 2.5 L, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 2.5L >> Disassembly And Assembly Of Subassemblies >> Piston >> Assembly

Disassembly And Assembly Of Subassemblies: Piston: Assembly

  1. Clean and inspect the piston and connecting rod. For additional information, refer to ENGINE SYSTEM-GENERAL INFORMATION .
  2. NOTE: Check each end of the piston pin for an identification mark. If present, install the piston pin with the identification mark toward the front of the engine.
    Fig 1: Installing New Piston Pin Retaining Ring
    G03419184Courtesy of FORD MOTOR CO.
  3. Install a new piston pin retaining ring into one side of the piston pin bore.
  4. Lubricate and start the piston pin in the piston and connecting rod.
    Fig 2: Lubricating And Start Piston Pin In Piston & Connecting Rod
    G03419185Courtesy of FORD MOTOR CO.
  5. Push the piston pin through the piston until it bottoms on the retaining ring.
  6. Install a new piston pin retaining ring on the opposite side of the piston pin bore.
    • Make sure that the connecting rod moves freely after assembly.
      Fig 3: Installing A New Piston Pin Retaining Ring
      G03419186Courtesy of FORD MOTOR CO.
  7. Check the end gap of all piston rings. For additional information, refer to ENGINE SYSTEM-GENERAL INFORMATION .
  8. NOTE: Install piston rings from the top side of piston. Avoid scratching the Teflon coating on the piston skirts if present.
    NOTE: Assemble the lower compression ring with the scraper groove down.
    NOTE: Position the oil control ring spacer so the cut ends are pointed toward the piston dome.
  9. Install the piston rings.
    1. Install the two oil control ring segments and spacer.
    2. Use a piston ring expander and install the two compression rings.
      Fig 4: Installing Piston Rings
      G03419187Courtesy of FORD MOTOR CO.
  10. Position the compression rings, oil control rings and expander gaps.
    1. Position the oil control segment ring gap.
    2. Position the expander ring and lower compression ring gaps.
    3. Position the upper compression ring gap.
      Fig 5: Positioning Compression Rings, Oil Control Rings & Expander Gaps
      G03419188Courtesy of FORD MOTOR CO.