Hub & Knuckle Assembly: Installation
- Position hub, knuckle and wheel bearing assembly onto axle shaft. Attach knuckle-to-strut. Install strut-knuckle bolt and nuts, and tighten to specification. See TORQUE SPECIFICATIONS .
- Install ABS sensor. Tighten bolt to specification. Install tie rod end onto knuckle. Install tie rod end nut. Tighten tie rod end nut to specification, and install NEW cotter pin. Position lower ball joint partially into wheel knuckle, and start lower ball joint nut. Tighten lower ball joint nut to specification, and install NEW cotter pin. Install brake rotor and brake caliper, and tighten bolts to specification.
- Install outer wheel bearing retaining washer and hub retaining nut. Apply brakes, and tighten hub retaining nut to specification. Install NEW cotter pin. If removed, install steering stop bolt, aligning marks made during removal. Tighten steering stop bolt jam nut to specification. Install wheel, and lower vehicle.