Clutch Assembly: Removal
- Disconnect negative battery cable. On Capri non-turbo, remove battery, air cleaner assembly, and clutch slave hydraulic line retaining bracket and cylinder. On Capri turbo, loosen clutch cable adjuster nut and disengage cable from release lever.
- On Capri turbo, remove air intake by-pass valve mounting nut. On all models, remove starter. Disconnect back-up light switch and neutral switch. Disconnect ground cable/strap and supporting brackets. Disconnect speedometer cable from transaxle.
- Install Three Bar Engine Support (D88L-6000-A) to engine hanger. See Fig 1 . Remove top transaxle-to-engine bolts. Raise vehicle. Remove bolt and nut retaining shift rod to input shift rail. Drain transaxle fluid. Remove all support brackets attached to transaxle. Remove front wheels.
- Remove engine splash shields. Remove front stabilizer bar. Disengage right and left side drive axle shafts from transaxle and support out of the way. On Capri turbo, remove intermediate shaft and support bearing assembly. See the AXLE SHAFTS - FRONT article in the DRIVE AXLES section.
- On Capri, remove 2 front crossmember braces and brace to "A"arm support bolts. Remove exhaust hanger from crossmember. Remove crossmember bolts in sequence, and remove crossmember. See Fig 2 . Remove transaxle end plate bolts.
- Place transmission jack under transaxle, ensuring it is secure. Remove remaining flywheel housing bolts. Lower transaxle by loosening engine bracket bar hook bolt. Pull transaxle away from engine and lower from vehicle.CAUTION: DO NOT allow oil or grease to contact clutch disc face or mating surfaces. Handle disc by edges. DO NOT touch face.
- If reusing pressure plate, mark pressure plate-to-flywheel position for installation reference. Remove pressure plate retaining bolts evenly. See Figure . To avoid dropping clutch assembly while removing bolts install clutch aligner. Remove pressure plate, clutch disc and clutch aligner. Remove flywheel. Remove pilot bearing from flywheel (if replacing).