LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1988 >> Tracer 4D Hatchback, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> MPFI System >> Circuit Tests >> Test FB - Inhibitor Switch (Automatic Transaxle)

Test FB - Inhibitor Switch (Automatic Transaxle)

To prevent possible replacement of good components, check transaxle operation and inhibitor switch installation. Also, visually inspect wiring, wiring harness and other related components for damage.

  1. Voltage At ECA From Inhibitor Switch: Using DVOM on 20 volt scale, measure voltage between pins No. 2 and 40 (ground). With ignition on, reading should be less than 1.5 volts. With engine cranking, reading should be 7-9 volts. Also, measure voltage between pins No. 5 and 40 (ground). With transaxle in Park or Neutral and ignition on, reading should be less than 1.5 volts, and with engine cranking, reading should be 7-9 volts. If readings are within specification, replace ECA. If readings are not within specification, proceed to next step.
  2. Power At Inhibitor Switch: Using DVOM on 20-volt scale, measure voltage between inhibitor switch (Black/Yellow wire) and ground. With ignition on, reading should be less than 1.5 volts. With engine cranking, reading should be 7-9 volts. If reading is within specification, proceed to next step. If reading is not within specification, proceed to step 4).
  3. Continuity Across Inhibitor Switch: Turn ignition off and unplug switch. Using DVOM on 200-ohm scale, measure resistance between inhibitor switch Black terminals in transaxle gear ranges. With transaxle in Park and Neutral, reading should be greater than 5 ohms. With transaxle in all other ranges, reading should be less than 5 ohms. If resistances are within specification, repair open in Black/Yellow wire from ignition switch to inhibitor switch. If resistances are not within specification, replace inhibitor switch.
  4. Power At Ignition Switch: Plug in inhibitor switch. Using DVOM on 20-volt scale, measure voltage between ignition switch (Black/Yellow wire) and ground. With ignition on, reading should be less than 1.5 volts. With engine cranking, reading should be 7-9 volts. If readings are okay, repair open in Black/Yellow wire from ignition switch to inhibitor switch. If readings are not okay, diagnose battery and charging system.
Fig 1: Inhibitor Switch Circuit
G94545