Graphic Display Stoplight Warning Operating Incorrectly
- Determine if segment operates with stoplight-out. If okay, go to next step. If not, go to step 6).
- Turn ignition switch to "RUN" position. If segment light illuminates, then goes out after 5 seconds, replace light-out module. If not, ensure brake switch is adjusted correctly, If brake switch is okay, go to next step.
- Turn ignition switch to "OFF" position. Disconnect and remove brake switch. Using an ohmmeter, measure resistance of switch. See Figure . With plunger released, less than one ohm should be present. With plunger depressed, no continuity should be present. If okay, reinstall brake switch and go to next step. If not, replace switch.
- Turn ignition switch to "OFF" position. Disconnect graphic display connector. See Figure . Turn ignition switch to "RUN" position. Measure voltage between terminals No. 17 and 9. Battery voltage should be present. Depress brake pedal and voltage should drop to zero volts. Repeat test while measuring voltage between terminals No. 17 and 19. If okay, replace bulb. If not, go to next step.
- Turn ignition switch to "OFF" position. Disconnect light-out module connector. See Figure . Turn ignition switch to "RUN" position. Connect jumper wire between terminals No. 6 and 3 for left stoplight and 6-4 for right stoplight. Segments should illuminate. If okay, replace module. If not, repair open in circuit between module and graphic display.
- Turn ignition to "OFF" position. Disconnect light-out module connector. Turn ignition to "RUN" position. Using a voltmeter, measure voltage between terminals No. 2 and 6. Voltage should be approximately battery voltage. If okay, go to next step. If not, repair open in circuit.
- Disconnect speed sensor control module connector. Turn ignition switch to "RUN" position. Depress brake pedal and measure voltage between light-out module connector terminals No. 6-16. Battery voltage should be present. Release brake pedal and voltage should drop to zero volts. If okay, go to next step. If not, repair open in circuit between fuse panel and brake switch, or between brake switch and terminal No. 16 of light-out module.
- Turn ignition switch to "OFF" position. Using an ohmmeter, measure resistance between terminals No. 6 and 19 (left stoplight) and 6-14 (right stoplight). See Figure . Resistance should be less than 20 ohms. If okay, replace light-out module. If not, repair open in circuit between light-out module and stoplight.