Graphic Display Light-Out Warning Operating Incorrectly.
- Turn ignition switch to "RUN" position. All light-out warning systems should illuminate. Front light segments should go out after 5 seconds. Depress brake pedal. Rear light-out segments should go out. If okay, system is okay. If not, go to next step.
- Turn ignition switch to "OFF" position. Disconnect graphic display connector. Measure voltage between terminals with main light switch on & ignition switch in "RUN" position. See Figure
. See the LIGHT-OUT VOLTAGE CHECK
table. Turn ignition switch to "OFF" position, then "ON" after checking each pair of terminals. If okay, replace display bulb. If not, reconnect display and go to step 3).LIGHT-OUT VOLTAGE CHECK
Component Terminal No. Left Ft. Marker Low Beam (1) 17-4 Right Ft. Marker Low Beam (1) 17-13 Left Tail Light (2) 17-9 Right Tail Light (2) 17-19 (1) Should indicate battery voltage for 5 seconds, then drop to zero volts. (2) Should indicate battery voltage until brake pedal is depressed, then drop to zero volts. - Turn ignition to "OFF" position. Disconnect the light-out module connector. Turn ignition to "RUN" position. Connect a jumper wire between terminals. Segment should illuminate. Refer to the LIGHT-OUT JUMPER WIRE CHECK table. If okay, replace light-out module. If not, repair open in circuit between module and display.
LIGHT-OUT JUMPER WIRE CHECK
| Component | Terminal No. |
|---|---|
| Left Ft. Marker Low Beam | 6-9 |
| Right Ft. Marker Low Beam | 6-8 |
| Left Tail Light | 6-3 |
| Right Tail Light | 6-4 |