LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1988 >> Tracer 2D Hatchback, Standard >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel >> Testing >> Warning Indicator System (SCORPIO) >> Brake Pad Wear Light Operating Incorrectly

Brake Pad Wear Light Operating Incorrectly

  1. Turn ignition switch to "OFF" position. Disconnect brake pad wear sensors. Measure resistance between terminals No. 1 and 2, 1 and 3, and 2 and 3 of brake pad connector. See Figure . Resistance should be less than one ohm. Repeat test for each sensor. If okay, go to next step. If not, replace brake pads.
  2. Turn ignition to "OFF" position. Disconnect auxiliary warning system module connector. Measure resistance between sensor harness connector terminal No. 2 and ground. Resistance should be less than 20 ohms. If okay, go to next step. If not, repair open in ground circuit.
  3. Turn ignition switch to "OFF" position. Measure resistance between sensor harness connector terminal No. 3 and terminals of auxiliary warning system. See AUXILIARY WARNING SYSTEM TERMINAL ID  table. Resistance should be approximately 180 ohms. If okay, go to next step. If not, replace sensor harness connector.
    AUXILIARY WARNING SYSTEM TERMINAL ID

    Sensor Terminal No.
    Right Front 5
    Left Front 3
    Left Rear 19
    Right Rear 21
  4. Measure resistance between sensor harness connector terminal No. 1 and auxiliary warning module connectors as listed in the AUXILIARY WARNING SYSTEM TERMINAL ID  table. Resistance should be approximately 1380 ohms. If okay, reconnect brake sensors and go to next step. If not, replace sensor harness connector.
  5. Measure resistance between auxiliary warning system module terminal No. 16 and terminals in AUXILIARY WARNING SYSTEM TERMINAL ID  table. Resistance should be 180 ohms. If okay, replace module. If not, repair open in ground circuit.