LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1988 >> Tracer 2D Hatchback, Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Alternator & Regulator >> Testing (On-Vehicle) >> Alternator Test

Alternator Test

  1. Turn ignition switch to "OFF" position. Disconnect negative battery cable. Remove output lead from alternator terminal "B". See Figure and Figure . Install a 100-amp ammeter in series to "B" terminal and disconnected output lead. Install positive lead of ammeter to "B" terminal and negative lead to disconnected output wire.
  2. Install a digital voltmeter between alternator "B" terminal and battery positive terminal. Install positive lead wire of voltmeter to "B" terminal and negative lead wire to positive terminal. Reconnect negative battery cable.
  3. Start engine. Turn accessories on until ammeter indicates 20 amps. If voltmeter indicates .2 volts, system is okay. If voltage is greater than .2 volts, wiring is defective between alternator "B" terminal, fusible link and battery positive terminal.