Remove/Install Crankshaft Hall Sensor - AR15.12-P-2136XGC
Engine 177 in model 463
as of model year 2019
| Risk of injury . Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Remove rear bottom engine compartment lining. | AR61.20-P-1105XG | |
| 3 | Release and disconnect electrical connector (2) from crankshaft Hall sensor (B70). | ||
| 4 | Remove screw (1) and remove crankshaft Hal sensor (B70). | *BA15.10-P-1003-03M | |
| 5 | Seal the opening on the oil pan using suitable stop plugs. | Record plug |
Fig 2 |
| 6 | Install in the reverse order. | ||
| 7 | Read out and delete fault memory. | ||
| AD00.00-P-2000-04B | |||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 8 | Perform an engine test run and check the engine for proper function. |
POSITION SENSOR
| Number | Designation | Engine 177 | |
|---|---|---|---|
| BA15.10-P-1003-03M | Bolt, position sensor for crankshaft to oil pan | Nm | 9 |