LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2010 >> CL63 >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Electrical System - Engine -- Cl63 >> Testing & Repair >> Remove/install starter - AR15.30-P-7100SMG

Remove/install starter - AR15.30-P-7100SMG

ENGINE 156 in MODEL 216, 221 

Fig 1: Identifying Starter Components
G07320794Courtesy of MERCEDES-BENZ USA
REMOVINGINSTALLING Remove/install    
DANGER Risk of injury  caused by fingers being pinched or crushed  when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. Keep body parts and limbs well clear of moving parts. AS00.00-Z-0011-01A
DANGER Risk of death  caused by vehicle slipping or toppling off the lifting platform. Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. AS00.00-Z-0010-01A
DANGER Risk of explosion  caused by oxyhydrogen gas. Risk of poisoning and caustic burns  caused by swallowing battery acid. Risk of injury  caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Only pour battery acid into suitable and appropriately marked containers. AS54.10-Z-0001-01A
1 Disconnect ground line from battery NOTES Insulate ground line clamp as a protection against unintentional contact of dismounted ground line with ground point of battery. AR54.10-P-0003SX
NOTES Notes on battery All models AH54.10-P-0001-01A
2 Open engine hood    
3 Raise vehicle with lifting platform   AR00.60-P-1000SX
4 Remove bottom engine compartment paneling Vehicles without code (Z07) Top protection AR61.20-P-1105SX
5 Remove protection against accidental contact for electrical line for circuit 30 (1) on starter (M1)    
6 Dismount electrical line for circuit 30 (1) at starter (M1) TORQUE SPECIFICATION *BA15.30-P-1001-01O 
7 Remove circuit 50 (2) electrical line on starter (M1) TORQUE SPECIFICATION *BA15.30-P-1002-01O 
8 Unscrew bolts (7) of starter (M1) TORQUE SPECIFICATION *BA15.30-P-1003-01O 
9 Lead starter (M1) down and out    
10 Check ring gear on the drive plate for wear and damage IMPORTANT When replacing starter (M1)
IMPORTANT Rotate engine at center bolt of crankshaft in the direction of rotation.
 
11 Install in the reverse order    
12 Perform basic programming    
STARTER

Number Designation   Engine 156
BA15.30-P-1001-01O Nut, connection for circuit 30 Nm 15
BA15.30-P-1002-01O Nut, connection for circuit 50 Nm 8
BA15.30-P-1003-01O Bolt connecting starter to crankcase Nm 40