LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2006 >> R500 >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Mixture Formation -- R500 >> Basic Knowledge >> Self-adjustment of mixture formation, function - GF07.10-P-1029BK

Self-adjustment of mixture formation, function - GF07.10-P-1029BK

ENGINE 113.967 in MODEL 219 

ENGINE 113.964 in MODEL 164.1 up to model year 2008/AEJ 07 

ENGINE 113.971 in MODEL 251 up to model year 2008/AEJ 07 

Shown on model 219 

Fig 1: Mixture Formation Function Diagram
G07302028Courtesy of MERCEDES-BENZ USA
Fig 2: Lambda Control Factor Performance Graph
G07302029Courtesy of MERCEDES-BENZ USA

On vehicles fitted with a closed-loop controlled catalytic converter the lambda control determines the injection time so exactly that a certain fuel-air ratio is maintained in all operating states.

If faults occur, the ME-SFI [ME] control unit automatically makes a correction in the mixture formation. Here the lambda performance map is shifted within certain limits in such a way that the lambda control is not at the upper or lower regulation limit (d).

The following faults require a mixture adjustment:

If the mixture composition constantly drifts out of the middle control range (e.g. 0 10%) the ME-SFI [ME] control unit under certain operating conditions shifts the lambda map sufficiently far until a lambda control factor of approx. 0% (g) is again achieved.

Self-adjustment ensures that the mixture composition in the control mode (e.g. warming-up phase) is neither too rich nor too lean. This also prevents the lambda control from moving up to the control limit at high altitudes.

Example: 

As the result of a lean fuel/air mixture the readout of the lambda control factor changes to 18 % (e). Under certain operating conditions the lambda performance map is shifted (arrow) by the ME-SFI [ME] control unit.

This shifting of the lambda performance map is the self-adjustment of the mixture formation process to the existing air/fuel mixture. After this self-adjustment the lambda control factor is again in the central control range (g).

This self-adjustment of the mixture formation can be carried out in the following operating states:

The following actual values can be read out using STAR DIAGNOSIS

Representation of self-adjustment values with STAR DIAGNOSIS in idle 

The representation in milliseconds means that the value displayed is added to, or subtracted from, the air mass inducted by the engine in order to determine the injection time.

The maximum correction value is ±1 ms.

Example:

Calculated injection time (performance map): 3.0 ms

Displayed correction value: +0.3 ms

The ME-SFI [ME] control unit uses a calculated value of 3.3 ms for determining the injection time (fuel injection quantity) (3.0 ms+0.3 ms).

Representation of self-adjustment values with STAR DIAGNOSIS for partial load 

The representation of the factor means that the indicated value for determining the injection time is multiplied by the air mass inducted by the engine.

The correction factor lies between 0.68 and 1.32.

Example:

Calculated air mass: 150 kg/hour

Displayed correction value: 1.10

A calculated air mass value of the of 165 kg/h is used by the engine control unit to determine the injection time (fuel injection quantity).

  Component description for ME-SFI [ME] control unit   GF07.61-P-6000BK 
  Component description for O2 sensors   GF07.04-P-6100BK