LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2006 >> R500 >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Mixture Formation -- R500 >> Basic Knowledge >> ME fuel supply, function - GF07.61-P-3004BK

ME fuel supply, function - GF07.61-P-3004BK

ENGINES 113.967 in MODEL 219 

ENGINES 113.964 in MODEL 164.1 up to Model Year 08/Modification Year 07 

ENGINES 113.971 in MODEL 251 up to Model Year 08/Modification Year 07 

Shown on model 219 

Fig 1: ME Fuel Supply Function Diagram
G07302053Courtesy of MERCEDES-BENZ USA

The fuel supply system must make available to the fuel injection valves an adequate quantity of filtered fuel from the fuel tank, and at an adequate pressure (injection pressure), in all operating conditions.

The fuel pump in the delivery module (88) draws the fuel out of the right chamber in the fuel tank (75) and pumps it through the fuel filter with integrated diaphragm pressure regulator (55/2) to the injectors connected to the rail (single-line system).

The fuel in the left chamber is pumped along a connecting line with a suction spray pump to the right chamber.

The pressure regulator regulates the fuel pressure to approx. 3.8 bar. The fuel pressure is regulated independently of the intake manifold pressure.

The return line from the fuel pressure regulator supplies the suction jet pump for filling the swirl pot in the fuel tank.

The voltage supply for the fuel pump is performed via the fuel pump relay.

The fuel injectors operated by the ME-SFI control unit, spray the finely atomized fuel into the inlet port.

IMPORTANT If the fuel pressure is too low, combustion misfires can occur and can be retracted in the diagnostic trouble code memory. The cause can be, for example, a contaminated fuel filter.

In these cases, check the fuel pump delivery rate at the feed to the fuel distributor rail.

Fuel vapors out of the fuel tank are intermediately stored in the activated charcoal canister (77) and, burnt in the engine via the purge control valve when purging is enabled.

USA ONLY The activated charcoal canister shutoff valve and fuel tank pressure sensor are necessary for the checking the leaktightness of the purge system.

  ME-SFI [ME] control unit, component description   GF07.61-P-6000BK 
  Voltage supply of ME-SFI control unit, function Model 219 GF07.61-P-5001BK
    Model 164.1, 251 GF07.61-P-5001BM 
  Fuel injection valves, component description   GF07.03-P-6010BK 
  Component description for fuel pump relay   GF47.20-P-2010BK
  Component description for the fuel filter with fuel pressure regulator   GF47.20-P-2110BK
  Component description for the fuel distribution rail   GF07.61-P-6020BK 
  Component description for fuel tank Model 219 GF47.10-P-2000BK
    Model 164.1, 251 GF47.10-P-2000BM
  Component description for fuel pump   GF47.20-P-2000BK
  Activated charcoal canister, component description   GF47.30-P-2010BK
  Component description of fuel level sensor   GF47.10-P-2010BK
  Component description for the fuel tank pressure sensor USA ONLY GF47.30-P-2100BK
  Activated charcoal filter shutoff valve, component description USA ONLY GF47.31-P-2100BK
  ME-SFI fuel pump actuation, function   GF07.61-P-3012BK 
  ME-SFI safety fuel shutoff, function   GF07.61-P-3018BK