Emergency tensioning retractor with airbag control module, function - GF91.60-P-4006-04B
The airbag control module (N2/7) (as of 01.09.02 restraint systems control module (N2/7)) detects via two integral, redundant acceleration sensors:
- The deceleration acting on the vehicle in the longitudinal direction in the event of a head-on collision
- The acceleration acting on the vehicle in the longitudinal direction in the event of a rear end collision
- The acceleration acting on the vehicle in the transverse direction in the event of a side collision
In addition the control module detects:
- The signals from the left side airbag sensors (A53/1) (as of 01.09.02 left side airbag and window airbag sensor (A53/1)) and right side airbag (A54/1) (as of 01.09.02 side airbag sensor and right window airbag (A54/1))
- The switch status of the switches for the buckle (driver) (S68/3) and buckle (front passenger) (S68/4) (only
version up to 31.08.02)) (as of 01.09.02 on models 215, 220 left front seat belt buckle restraint systems switch (68/3) and right front seat belt buckle restraint systems switch (S48/4))
- Via the electronic analysis system for passenger seat occupied and child seat recognition (B48) (as of 01.09.02 passenger seat occupied and child seat recognition sensor, the current status of the front passenger's seat)
The control module links all the signals detected and in the event of a collision accurately triggers the airbag/side airbag/window airbag and emergency tensioning retractor units which are required for the best possible occupant protection.
To protect against incorrect triggering under normal driving conditions, e.g. due to EMC influences, an additional safety sensor is integrated in the control module. This sensor which also has the function of a switch only responds to decelerations which have been caused by a head-on collision. It is looped into the ignition circuits of the driver's and front passenger's airbag and when triggered conducts the full ignition current.
The safety sensor is not looped into the ignition circuits of the driver's and front passenger's emergency tensioning retractors. However, its control status is interrogated by the control module before triggering the emergency tensioning retractors. The emergency tensioning retractors are only triggered where it responds to the deceleration as it occurs.
The safety sensor remains inoperative in side collisions. Here additional protection against incorrect triggering is created by a plausibility check carried out in the control module. In this connection the signals received from the side airbag sensors are compared with acceleration values measured internally.