Backup Power Supply Removal/Installation
D-code
- 677G0A
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Remove the following parts:
- Passenger-side front seat (See FRONT SEAT REMOVAL/INSTALLATION .)
- Passenger-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
- Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
- Passenger-side side wall (See SIDE WALL REMOVAL/INSTALLATION .)
- Partially peel back the floor covering.
- Perform the following procedure to allow the backup power supply to deplete its stored power.NOTE:
- While the power stored in the backup power supply is being depleted, the door latch and lock actuator does not operate. This does not indicate an improper procedure. Continue to perform the procedure.
- After performing Step 3 and the door latch and lock actuator starts to operate, the door lock switch (driver's side) no longer needs to be operated.
- Close the front door (driver's side).
- Open the front door (driver's side).
- Within 30 s after performing Step 2, press and hold the unlock side of the door lock switch (driver's side) for 5 s or more.
- Wait until the door latch and lock actuator stops.
- Remove using the procedure shown in the figure.
Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATIONStep Part name 1 Nut 9.5 N.m {95 kgf.cm, 82 in.lbf} 2 Connector - 3 Clip - 4 Backup power supply component - 5 Nut 9.5 N.m {95 kgf.cm, 82 in.lbf} 6 Backup power supply - - Install in the reverse order of removal.