Vehicle-side Connector Cutting
- If tubing or electrical tape is used to protect the connector wiring harness, cut into it being careful not cut or damage the wiring, and expose approx. 200 mm {7.84 in} of the wiring from the connector.
- Cut the wiring harness once at the position near the connector so as to leave a long length of wiring harness on the vehicle side, align the length with the repair-use connector wiring harness, and then recut at the wiring harness on the vehicle side or the repair-use connector wiring harness at the appropriate position.CAUTION:CAUTION:
- Cut longer in consideration of the amount of wiring harness length which will be soldered.
- If the cut wiring harness length is different than the repair-use wiring harness length, the following problems may occur.
- If too short: Tension will be applied to the terminal, wiring harness connection area, or the connector resulting in an open circuit.
- If too long: A short may occur due to pinching and wear of the extra length of wiring harness near the connector.